1. Ribbon fracture

2. The ribbon motion sensing signal is interrupted

3. Ribbon was stuck

4. Wear or breakage of the driving belt of the ribbon driving wheel

1. Automatic printing shutdown

2. Print the fuzzy

3. Printed labels blur for a short time

4. The printer prints only empty paper and does not print out the data.

5. The printer makes a sound of two short beeps intermittently

1. Red color can not be printed out.

2. The printing is intermittent.

3. Light printing.

1. If one or more vertical lines are found on the label surface, what should be done?

2. How do I solve the problem that there are multiple slanted white stripes on a label?

3. The carbon tape is correctly matched with the label, but the text cannot be printed. No error is reported on the printer or computer. How to solve this problem?

1. Cut continuously

2. Print blank

3. Key and indicator light

4. Print blurring

5. Check the printer battery display through APP

6. Set the function of paper shortage threshold, which cannot be used, and no reaction occurs when you click the button

7. Stuck in "Sending... ", and then the printer was disconnected

8. The error message "Gap cannot be found" is displayed, and the printing cannot continue

9. The device is often disconnected and needs to be reconnected (most of the cases are automatically connected).

10. The left and right spacing of the printed output is somewhat large, which is not consistent with the setting on the APP, and the upper and lower spacing is also different from the actual

11. Report gap detection errors when printing a few papers

12. Detect paper and paper deficiency

1. Short print life

2. Some of the printing is dark, some is light

1. Why does the ink strip come out with the D1 tag strip when I print the label?

2. Is the material of our ribbon shell PET?

3. Is the band of RL-D-45013P made of polyester or vinyl?

4. Is the case of Rhino ribbon the same case?

5. D1 series: 1) Is it waterproof, friction-proof and can it be exposed to the sun? Can it be used outdoors? 2) Is it corrosion resistant (such as oil and salt in the kitchen, acid and alkali in the factory, etc.)?

1. Daily maintenance of printer

2. Print paper away from the paper

3. The print is not clear and the quality is poor

4. When printing, the label goes, the carbon does not go

5. Why does the barcode printer occasionally show some spots on the label

6. What is the problem when the printing temperature is too high

7. Printing paper positioning is not accurate, there is up and down offset or jump

8. When I print, I find that the carbon has creases

9. Load the paper, lock the print head, and the screen shows that no paper is detected

10. There are white bars in the fixed position of the printed content

1. Light printing

2. The gear wheels stop and ribbon stop running

1. RL-B-Fx-T231 cannot be used on PT-E115B machines

2. Why does the printed label have black or white horizontal lines or the printed content is unclear?

3. Why couldn't take out the ribbon?

4. What are reasons of printer tapes caused by labels?

5. Does the strength of the label tear reflect the stickiness?

6. Where are the zebra bands of Series B products affixed? What is the purpose of a zebra belt?

7. The label head printed for series B products has no content and is very wasteful. Is there any way to avoid it?

1. Daily maintenance of printer

2. Go blank paper

3. The paper doesn't go well or doesn't come out

4. The paper is slanted out during the printing process, and the printing is incomplete

5. Printing is not clear, there are white bars or print blurred

6. The paper is loaded into the paper bin, but the screen shows that no paper is detected

7. The paper bin lid is closed but the screen shows that the paper bin lid is opened

1. The inked nylon is worn-out during printing.

2. After changing the inked nylon,the tape is twisted.

3. Short print life

4. Ribbon can not run